The Triumph Experience RSS Feed

Has anyone customized a dual Ansa exhaust in order to quiet it down. ^^ CLICK LINK TO REPLY

I got a problem that I don’t understand. After disassembled my carburetors and cleaned them in my ultrasonic cleaner there is a sound from the front carburetor housing,
like something is loose in it when I shake it .
Its just the housing, all parts are gone from it and what I understand the housing is just a solid cast with ports.
Can there be something in the cho...

Solid seat frames for a 69 TR6. These are unique to the 69 where the headrests flip up. Perfect if you need them to finish your TR correctly. Included are a set of slides. Ideally these would be picked up in Bellingham, WA or southern, BC. Shipping would be for actual expense. Thanks! ^^ CLICK LINK TO REPLY

Hello group,
As part of the conversion to fuel injection, I have to run an additional temp sensor and needed to use the manifold heater tap near the thermostat housing. The provided sensor required the existing hole was drilled and tapped to 3/8" PIPE thread (18 tpi). I noticed the new sensor probe end and the existing gauge sensor probe looked like they might bottom agains...

My 6 was due for an oil change, valve adjust and plugs. Got it done and double checked the gaps, all good. Now, no start. Plugs seem wet, so I suspected no spark. But, I saw a spark from number one to the head so I think I have spark. Never had this issue before. It has been running good, but a little ragged, rough idle. I have a pertronics and it’s old. Also a sports coil. Need...