The hydraulic rams for my arms and bucket aren’t closing. The rams open fine but neither will close. Bobcat was working fine this morning until both went out at the same time.

I have an 1999 Lx665. One of the bucket cylinders is leaking. I have the service manual and I went through the entire removal procedure fine until the last step. The last step before it says to remove the cylinder says “Support the cylinder and, with a hammer, strike the cylinder at the base area to loosen the tapered pivot pin”. I did as the manual said and it did allow the tap...

I have a 40XT that I was using yesterday with no issues then all of a sudden lost my right side steering control. No forward or reverse. The left side works fine. This happened to me a few years ago and the mechanic I took it to finally figured out it was an electrical issue but never told me exactly what he did and he's gone now. I've tried messing with the solenoid block wirin...

I used my casr 40xt parked it and went to get it the other day and the arms move and the tilt on the bucket works but no drive...any idea on where to start? Was wondering if a sensor or my lap bar still had the prking break on but there is no motor change ...its like it's not communicating with the joy stick.no lights on... Any help would be appreciated.
Thx
Carrie

Where do the 2 inch balls go on a Bobcat 843 in order to mount a Bobcat 911 backhoe attachment? Any other advice on this attachment would be very helpful, as I just got an old 911 and looks like it needs a lot of help.