GT40s

Gents assembled the rear end ,renault un1 box,108 mm adapters,driveshafts fitted,on the rear shocks ive set ,so ive got 25mm gap between the top of tyre to arch,my question is now the car is down on the floor and settled,im checking the float in the driveshafts ,ive got again approximately 21mm of play,if i move the shaft all the way to the outer ,then back towards the gearbox.w...

2015 RCR SuperLite SL-C Coupe for sale. RCR assembled roller, motor, trans, etc., the rest of the work was performed in California. Never titled, extremely low miles driven on main roads only, no track. LS3 ASA 525HP, Graziano trans, shift gate, front clearance Spring lift, street tail, rear window vent kit, Corvette rims, Momo steering wheel, Isis ECU, custom exhaust, custom in...

so i started on this project late feb this year have made some small progress

Figured it's time to start this post.
I placed the order on 12/4/23. RCR just contacted me to send them tires so I figured it's getting close enough to start the build thread.

Kit details
RCR40 Mkl Deluxe Plus Kit
RHD
Single nostril panel
BRM 15x8/10
Hartwell-Style Latch Kit
Door Eyebrows
Door Boxes
G96/01 LSD
302 headers

Good site for fastener torque numbers on an aluminum Gen IV LS3? Found a few but they seem off. Tightening seems “soft” rather than firm when approaching torque. I don’t want to overtorque and strip threads, so confirming I have the right numbers would be helpful.