Dental Lab Network

Hello
I make between 10 to 15 bite guards a week, using Keysplit soft material.
This one patient, we've made her 2 different splints and they both turned green as you can see in the pictures.
The green color was mostly on the inside of the splint.
The patient has some implants and few crowns in her mouth.
Did any of you have any experience with this.
Thanks

Hi Friends

Which AI you recommend for CAD; models, crowns, bridges, implants? have you ever used Relu?
Thanks

I am looking for a used (suction) better to be RENFERT ... even it was scrap

We have experimented with the system a little with not too much success honestly but was wondering if anyone has been using these long term in their lab. We are mainly interested in the guided articulation that comes when using them combined with the jaw motion data generated by Bite Finder.

Hey everyone. I'm a doctor in a big group practice with an internal lab, and I'm the liaison between the doctors and the lab. I was hoping you could help me out with this. Our lab mills zirconia crowns, the after they're sintered, they trim back the margins manually. Whenever there's a margin issue, my doctors say that the error is caused by the manual trimming, and that other l...