Color Printing Forum

No 0-10V control signal to frequency converter from SAP 029587 PCB.causing back gauge to run very slowly.
Does anyone have a suggestion as to which component of the SAP circuit board is defective?

Main compressor won't start when machine is switched on, G30 error comes on. Circuit Breaker not tripped in the electrical board, Machine cannot run unless if theres air being supplied to the pneumatic parts inside the machine. Need advice on how to get the compressor running again.

Have a problem with FE Zero position calibration with BF module. Would be great if someone could help.

Dear Sir
I have SORMZ 2 color Heidelberg machine that has the problem with the dampening motor that stops running as it goes on impression otherwise manually it runs smoothly, I have cross checked the motors, electronics cards and wiring for bothe that is normal but still during impression it dies not run kindly suggest for the remedy of the fault.

Hello,
I`v got about three weeks ago from German ebay Heidelberg Printmaster 46-2 machine, year 1999. I never had experiences with Heidelberg machines before, only some experiences on past with Hamada 700cdx and Multi 1650xt single colour machines.
The seller had to remove the big electrical cabinet from the machine to get the machine out of printing room. The sel...