Blog – Pelle Heating & Air Conditioning

Key Takeaways  A normal cooling cycle runs long enough to lower indoor temperature, then stays off for a reasonable period.  A thermostat can cause frequent cycling, but airflow, electrical faults, refrigerant conditions, and outdoor-unit overheating can look similar. Check settings, batteries, filters, and unobstructed vents before assuming the thermostat has failed. Repeate...

Key Takeaways  A compressor that starts and stops after a few minutes is often short cycling, not normal cooling operation.  Thermostat settings, restricted airflow, and outdoor-unit blockage are safe first checks for homeowners. Electrical, refrigerant, fan, and compressor faults can all trigger a protective shutdown. Repeated breaker resets or forced restarts can make an un...

Key Takeaways  Evaluate cooling reliability before heavy demand turns a manageable decision into an urgent one.  A dependable system may only need routine professional attention before summer. An isolated problem can justify targeted service, but repeat issues deserve a broader review. Replacement planning should consider ductwork, sizing, thermostat compatibility, and instal...

Key Takeaways  Square footage alone cannot tell you how much cooling capacity a home needs.  A load calculation examines the home’s heat gain, insulation, windows, ducts, and comfort goals. An oversized system can cycle too often, while an undersized system can struggle during heavy demand. The existing AC’s size may no longer fit a home that has changed over time. A profess...

Key Takeaways  Start with safe, simple checks before changing settings repeatedly.  Air moving from vents does not always mean the system is producing cold air. Shut the system down for electrical smells, ice, water near equipment, or alarming noises. Use temporary comfort measures while you wait, especially if indoor heat is becoming unsafe. Recurring nighttime cooling trou...